PC compounds
GRN-PC-N510
- Brand GRN
- GREENPOLYMER compound
- Base resin PC
- PC
- Focus N
- Halogen-free flame retardant
- Tier 5
- Flame-retardant tier
- Sequence 10
- Development sequence 10
Halogen-free flame-retardant PC
Example grade / typical values — to be corrected by GREENPOLYMER
A flame is applied as specified; afterflame time and whether drips ignite the cotton below decide the class
Description
Suitable parts
- Battery housings
- Charger housings
- Parts around air outlets
High heat resistance, impact resistant, halogen-free.
Key features
Applications
Related industries
Other grades in this family
Parameters
Example grade / typical values — to be corrected by GREENPOLYMER
| Property | Typical value | Test standard |
|---|---|---|
| An illustration, not a measurement: Immersion method: weighed in air, then in a liquid; buoyancy gives the density | 1.20–1.24 g/cm³ | ISO 1183 |
| An illustration, not a measurement: Melt is pushed through a die at a set temperature and load; cuts taken at fixed intervals are weighed300 °C / 1.2 kg | 8–20 g/10 min | ISO 1133 |
| An illustration, not a measurement: A dumbbell specimen is pulled at a constant speed and the stress–strain curve is recorded until it breaks | 60–68 MPa | ISO 527-1/-2 |
| An illustration, not a measurement: A pendulum breaks a notched bar supported at both ends; the energy it absorbs gives the result23 °C | 20–50 kJ/m² | ISO 179-1/1eA |
| An illustration, not a measurement: A loaded bar is heated in an oil bath at a steady rate; the result is the temperature at which it reaches the set deflection1.80 MPa | 115–128 °C | ISO 75-1/-2 |
| An illustration, not a measurement: A flame is applied as specified; afterflame time and whether drips ignite the cotton below decide the class1.5 mm; design target, subject to test report | V-0 | UL 94 |
Typical values. Refer to the actual TDS. Values are typical industry ranges for this material class, not GREENPOLYMER test data; to be corrected by GREENPOLYMER. Flammability rating, CTI, light transmittance and weathering: design target, subject to test report (for each grade).
Immersion method: weighed in air, then in a liquid; buoyancy gives the density
Contact us
Tell us about the part, material requirements, equipment and expected volume. We will recommend suitable grades and the validation data you need.